The Challenges to Swim Spa Covers

Swim Spas represent unique challenges when it concerns covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same reasons a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot more difficult.
Getting a new swim spa is an exciting event in life. You’re eagerly anticipating the workout you’ll obtain from using it. Possibly you’re a little relieved to have actually finally made a selection from the different designs you took a look at. At any rate, you most likely weren’t thinking much about the cover you would use.
Generally, the cover that gets back with your brand-new purchase will be a 4 area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style defect. Built in obsolescence because as quickly as it is placed in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper won’t make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are extremely little as they rise from the water surface. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It takes place gradually and on a Swim Spa Cover which is made from private sections, at differing speeds. So eventually you’ll see one or two of the areas are truly getting heavy. The bar lifters on completions of the swim spa aren’t much assistance because you still have to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com developed a new style for their Lightweight Swim Spa Covers
Instead of using a number of foam panels to construct Lightweight Swim Spa Covers that will ultimately wind up in some garbage dump, they designed one that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Lightweight Swim Spa Covers are easy to use, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or break down at the joints either. So if you own a swim spa, and you intend to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to purchase today, bookmark this website so you can discover it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *