The Challenges to Swim Spa Covers

Swim Spas represent distinct challenges when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot more difficult.
Getting a new swim spa is an exciting occasion in life. You’re anticipating the workout you’ll obtain from using it. Perhaps you’re a little relieved to have lastly selected from the different designs you looked at. At any rate, you probably weren’t believing much about the cover you would use.
Generally, the cover that gets back with your brand-new purchase will be a 4 section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence because as quickly as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are really small as they rise from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It occurs slowly and on a Swim Spa Cover which is made from specific areas, at varying speeds. So ultimately you’ll discover a couple of of the areas are truly getting heavy. The bar lifters on completions of the swim spa aren’t much assistance due to the fact that you still need to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a different design for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will eventually wind up in some landfill, they developed one that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or fall apart at the seams either. So if you own a swim spa, and you plan to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to order today, bookmark this site so you can discover it once again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *